Custom Panel

Remco can build you a custom soft start panel to start your three phase motors that either run off of a rotary phase converter or utility three phase at reduced motor current while retaining high torque. These cost-efficient controls require the motor to have 12 leads. Available range 15-125HP.

Soft-starting a motor will reduce your KVA demand, lowering monthly utility charges
Extends the life of the motor
Inexpensive to purchase and easily maintained
Completely factory prewired, ready-made with custom enclosures
Connects directly to the motor

State-of-the-art design and technology
Up to 1200 Horsepower
Custom enclosure with cooling fans or bypass controls
Cannot be used with rotary converters

SSW06 Line

The SSW06 is WEG’s third generation Soft Starter line. The keypad, with dual display, has red LED digits which provide visibility and make programming easier. Integral bypass contacts eliminate heat dissipation once the motor is at full voltage, which makes it extremely compact and allows for simple integration into non-ventilated enclosures and replacement of electromechanical starters in Motor Control Centers.

200 - 600V, 50/60Hz input power supply
Built-in run rated (AC1) bypass contactor
Duty cycle: 300% full load amps for 30 seconds, 10 starts per hour
Voltage ramp or current limit start modes
Detachable keypad with dual display (LCD and LED) and copy function
90 - 250Vac auxiliary control voltage
Single 32 bit RISC processor based control board
IP00 protected chassis enclosure
Six isolated 24Vdc programmable digital inputs
Three programmable relay outputs (2 Amp - 250V)
One 0 - 10Vdc programmable analog output
One 4 - 20mA programmable analog output

Motor PTC thermistor input
RS-232 serial interface
Adjustable acceleration and deceleration ramps (1 - 299 seconds)
Adjustable pedestal voltage (25 - 90% of line voltage)
Diagnostic features: Motor overload, over current and phase loss, motor immediate over and under current, SCR over temperature and fault, line phase loss and phase sequence, line over and under voltage
Display readings: Motor current, voltage, kW and power factor, line voltage and frequency, four last fault trips, run and power-up timers
Ambient: 32ºF (0ºC) to 131ºF (55ºC), 3300 ft (1000m) altitude, 90% non-condensing humidity